Table of Contents
Advertisement
Connecting and
Starting the Printer
Printer Setup
Thermo Scientific
1. Make sure the printer and Nanopure are turned OFF.
2. Connect the Nanopure to the printer via the RS232 port. Use the tan
printer cable included with the Epson printer. Plug the printer power
cord into an electrical outlet.
3. Turn the Nanopure ON.
4. Turn the printer ON.
5. From the (Idle) display, press the UP or DOWN arrow until display
reads, "Advanced Menu."
6. Press ENTER.
7. From the "Printer Attached" display, press the Up or DOWN arrow
for (YES).
8. Press ENTER.
9. Press BACK twice to return to the (Idle) mode.
10. During normal Recirculation mode, a purity and temperature reading
will be printed once every 12 minutes.
Located on the front of the printer (AY1137X1), the power switch turns
power to the printer ON and OFF. The POWER light will illuminate
when the printer is ON.
For additional setup and operation, refer to the instruction manual
included with the printer.
Section 11
Computer/Printer Setup
Nanopure Life Science (UV/UF)
11-3
Advertisement
Table of Contents
