Ip Igmp Snooping Querier - Dell C9000 Series Reference Manual

INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information Dell Networking OS provides the capability of statically configuring the interface to
which a multicast router is attached. To configure a static connection to the multicast
router, enter the ip igmp snooping mrouter interface command in the VLAN
context. The interface to the router must be a part of the VLAN where you are entering
the command.

ip igmp snooping querier

Enable IGMP querier processing for the VLAN interface.
C9000 Series
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet Group Management Protocol (IGMP) 1150