Ip Igmp Snooping Querier - Dell S4810 Reference Manual

Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
Usage Dell Networking OS provides the capability of statically configuring the interface to
Information which a multicast router is attached. To configure a static connection to the
multicast router, enter the ip igmp snooping mrouter interface command
in the VLAN context. The interface to the router must be a part of the VLAN where
you are entering the command.

ip igmp snooping querier

Enable IGMP querier processing for the VLAN interface.
S4810
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Command INTERFACE VLAN — (conf-if-vl-n)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
730
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Internet Group Management Protocol (IGMP)