Ip Igmp Snooping Querier - Dell Force10 Z9000 Reference Manual

Parameters
interface
interface
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
Usage FTOS provides the capability of statically configuring the interface to which a multicast router
Information is attached. To configure a static connection to the multicast router, enter the ip igmp
snooping mrouter interface command in the VLAN context. The interface to the
router must be a part of the VLAN where you are entering the command.

ip igmp snooping querier

Enable IGMP querier processing for the VLAN interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-
684
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
n )
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
n )