Debug Ip Igmp Snooping - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results.

debug ip igmp snooping

Enable debugging of IGMP snooping packets on interfaces and groups.
C9000 Series
Syntax
debug ip igmp snooping [group address | interface]
Parameters
snooping
group-address
interface interface
Defaults Disabled.
Command Modes EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on S-Series and Z–Series.
• To disable debugging of IGMP snooping, use the no debug ip igmp snooping
[group address | interface] command.
• To disable all debugging, use the undebug all command.
Enter the keyword snooping to enable debugging of IGMP
snooping.
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Enter the following keywords and slot/port or number
information:
•
•
•
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a port channel interface, enter the keywords port-
channel then a number.
Internet Group Management Protocol (IGMP) 1144