Debug Ip Igmp - Dell S4810 Reference Manual

Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
Information yield results.

debug ip igmp

Enable debugging of IGMP packets.
S4810
Syntax
debug ip igmp [group address | interface]
•
•
Parameters
group-address
710
• For a VLAN interface, enter the keyword vlan then the
slot/port information. The range is from 1 to 4094.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
To disable IGMP debugging, use the no debug ip igmp [group address
| interface] command.
To disable all debugging, use the undebug all command.
(OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
Internet Group Management Protocol (IGMP)