Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
Use this command on the interfaces where the DHCP clients are connected to
Information
forward the packets from clients to DHCP server and vice-versa.
Example
Dell(conf-if-fo-0/124)#ip helper-address vrf jay 10.0.0.2
show ip dhcp snooping
Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
S4810
Syntax
show ip dhcp snooping [binding | source-address-validation]
Parameters
binding
source-
address-
validation
Defaults
none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 7.8.1.0
636
Introduced on the S-Series and Z-Series.
Display the binding table.
Display the interfaces configured with IP Source Guard.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
Dynamic Host Configuration Protocol (DHCP)