Syntax
ip arp inspection limit { none | rate
no ip arp inspection limit
•
none — To set no rate limit.
pps — The number of packets per second (Range: 0–300).
•
•
seconds — The number of seconds (Range: 1–15).
Default Configuration
The default rate limit is 15 packets per second.
The default burst interval is 1 second.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g1)#ip arp inspection limit none
console(config-if-1/g1)#ip arp inspection limit rate 100 burst
interval 2
ip arp inspection trust
The ip arp inspection trust command configures an interface as trusted for Dynamic ARP
Inspection. Use the "no" form of this command to configure an interface as untrusted.
Syntax
ip arp inspection trust
no ip arp inspection trust
Default Configuration
Interfaces are configured as untrusted by default.
Command Mode
Interface Configuration (Ethernet) mode
226
pps
seconds
[ burst interval
] }