Dell S6100 Configuration Manual page 54

PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ip prefix-list command and the name for the prefix list. The prompt changes to include conf-nprefixl.
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, see
Registration (GVRP).
To enter PROTOCOL GVRP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol gvrp command. The prompt changes to include config-gvrp.
You can return to CONFIGURATION mode by using the exit command.
RAPID SPANNING TREE (RSTP) Mode
To enable and configure RSTP, use RSTP mode. For more information, see
To enter RSTP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol spanning-tree rstp command. The prompt changes to include conf-rstp.
You can return to CONFIGURATION mode by using the exit command.
ROUTE-MAP Mode
To configure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the route-map map-name [permit | deny] [sequence-number] command. The prompt changes to include
config-route-map.
You can return to CONFIGURATION mode by using the exit command.
ROUTER BGP Mode
To enable and configure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information, see
IPv4 (BGPv4)
To enter ROUTER BGP mode:
54 CLI Basics
Rapid Spanning Tree Protocol
GARP VLAN
(RSTP).
Border Gateway Protocol