Dell S6100 Configuration Manual page 51

Prompt Interface Type
Dell(conf-if)# INTERFACE mode
Dell(conf-if- Ten-Gigabit Ethernet interface then stack/slot/port/subport information
te-1/1/1/1)#
Dell(conf-if- Twenty-five Gigabit Ethernet interface then stack/slot/port/subport information
tf-1/1/1/1)#
Dell(conf-if- Forty-Gigabit Ethernet interface then stack/slot/port/subport information or stack/slot/port information,
fo-1/1/1/1)# depending on the module used
Dell(conf-if- Fifty-Gigabit Ethernet interface then stack/slot/port/subport information
fi-1/1/1/1)#
Dell(conf-if- Hundred-Gigabit Ethernet interface then stack/slot/port information
hu-1/1/1)#
Dell(conf-if- Loopback interface number
lo-0)#
Dell(conf-if- Null Interface then zero
nu-0)#
Dell(conf-if- Port-channel interface number The range is from 1 to 4096.
po-1)#
Dell(conf-if- VLAN Interface then VLAN number (range 1–4094)
vl-01#
Dell(conf-if- Management Ethernet interface then slot/port information
ma-1/1)#
Dell(conf-if- Tunnel interface then tunnel ID.
tu-0)#
Dell(conf-if- Designated interface range (used for bulk configuration).
range)#
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list
standard command or the ip access-list extended command.
To enter IP ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter either the ip access-list standard command or the ip access-list extended command. Include a name for
the ACL. The prompt changes to include conf-std-nacl or conf-ext-nacl.
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see
System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
Intermediate System to Intermediate
CLI Basics 51