Gts And Rate Limit Configuration Commands; Gts Configuration Commands; Display Qos Gts Interface - HP A8800 Series Command Reference Manual

GTS and rate limit configuration commands

In this chapter, SPC cards refer to the cards prefixed with SPC, for example, SPC-GT48L. SPE cards refer
to the cards prefixed with SPE, for example, SPE- 1 020-E-II.

GTS configuration commands

display qos gts interface

Syntax
display qos gts interface [ interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display qos gts interface to view generic traffic shaping (GTS) configuration information on the
specified interface or all the interfaces if no interface is specified.
With GTS enabled on an interface, this command can display the GTS configuration information of the
interface regardless of the interface state (up or down).
Examples
# Display the GTS configuration information on GigabitEthernet 2/1/5.
<Sysname> display qos gts interface GigabitEthernet2/1/5
Interface: GigabitEthernet2/1/5
Rule(s): If-match any
CIR 160 (kbps), CBS 10240 (byte)
80