Traffic policing, GTS, and rate limit commands
Traffic policing commands
display qos car interface
Use display qos car interface to display the CAR settings and operational statistics on a specified
interface.
Syntax
display qos car interface [ interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If no interface is specified, this command displays the CAR settings and operational statistics on all the
interfaces.
If a VT interface is specified, this command displays QoS CAR information of all VA interfaces inheriting
the VT interface, but does not display QoS information about the VT interface.
Examples
# Display the CAR settings and operational statistics on GigabitEthernet 1/0/1.
<Sysname> display qos car interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
Direction: Inbound
Rule(s): If-match Any
CIR 10 (kbps),
Green Action: pass
Red Action : discard
Green : 0(Packets) 0(Bytes)
CBS 2000 (byte),
EBS 0 (byte)
74