NEC Univerge sv8500 Manual page 1625

[Setting Example]
MG(SIP) > set cdn_pattern
Select Called Party Number to which you give
priority.
0=To[userinfo](default)
1=Request-URI[isub]
2=Request-URI[userinfo]
3=P-Called-Party-ID[userinfo]
4=P-Called-Party-ID[isub]
Input:0
Note:
Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
(11) check_number
Setting a limit to the letters and numerals that can be used for calling/called party number
This command is used to assign a function that permits only numerals for calling/called party number sent
via the Telephony Server network.
[Setting Example]
MG(SIP) > set check_number
Select the setting of function to delete
[#] in telephone-number.
0=disable(default)
1=enable
Input:0
Note:
Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
(12) codec_change
Setting of Codec Change function and G711 Fax renegotiation
This command is used to enable Codec Change function and G711 Fax renegotiation.
Codec Change function enables a call to be retained when a forwarding call is placed to a destination lo-
cated in the SIP network and the payload type is different between an intermediate station and the desti-
nation.
G711 Fax renegotiation enables a called party to receive a facsimile with Fax Pass Through when com-
munication is changed over to a FAX communication while a call is in progress with G.729a.
[Setting Example]
MG(SIP) > set codec_change
0: Disable (default)
1: Limit to numerals only
VOL.2-1372
MG-SIP128 [MG-128SIPMGG]
0: userinfo part of the To header is
given priority (Default)
1: isub of Request-URI is given priority
2: userinfo part of Request-URI is
given priority
3: userinfo part of P-Called-Party-ID is
given priority
4: isub of P-Called-Party-ID is given
priority