NEC Univerge sv8500 Manual page 1653

• This command is required only when SIP domain must be separated between the SIP server and MG-SIP128
[MG-128SIPMGG].
• If this command is not set, the SIP domain set by "set sip_server" command is used for the SIP domain of
MG-SIP128 [MG-128SIPMGG].
(46) session_timer
Setting of session timer
This command is used to specify the Session Timer.
[Setting Example]
MG(SIP) > set session_timer
Select the setting of Session-timer.
0=enable(default)
1=disable
When Session-Timer is Enable (=0) is selected:
MG(SIP) > set session_timer
Select the setting of Session-timer.
0=enable(default)
1=disable
Input:0
Input Session-expires timer value.(sec)
(0-86400(default=180)):180
Select Refresher type.
0=UAC(default)
1=UAS
Input:0
Select "refresher=uac" ini-INVITE.
0=disable(default)
1=enable
Input:0
Select Forced mode.
0=disable(default)
1=enable
Input:0
VOL.2-1400
MG-SIP128 [MG-128SIPMGG]
0: Session Timer is enabled (Default)
1: Session Timer is disabled
Set the session timer.
(Default: 180sec)
Determine a point to make refresher.
UAC: User Agent Client
UAS: User Agent Server
refresher=uac addition to INVITE mes-
sage:
0: refresher=uac is not added
1: refresher=uac is added
0: Session timer will not be activated
when Supported/Require header does
not exist (default).
1: Session timer will be activated by
using Session-Expires when Sup-
ported/Require header does not exit.