NEC Univerge sv8500 Manual page 1433

• Host Name of MG(PRI)
Specify the host name of MG(PRI) when DNS Server is enabled.
MG-PRI(SIP)> SET OWN_NAME mgpri.nec.com
Own name setting succeeded.
IP addresses assigned here will not be effective if DHCP server is set to "Enabled". Be sure to assign "SET
Note 1:
DHCP DISABLED" before starting the IP address setting.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 2:
tions" in INTRODUCTION of Installation Manual.
STEP 5: Save the configuration data assigned
.
MG-PRI(SIP)> SAVE CONFIG
** Don't power off in progress **
Do you need save? [Y/N]:Y
Erase start...
Erase OK!
Write start...
Write OK!
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
STEP 6: Reboot the MG(PRI) by turning the power OFF
MG-PRI(SIP)> REBOOT
Do you need reboot? [Y/N]:Y
MG-ID (MAC Address of MG(PRI)) is displayed after rebooting. The MG-ID needs to be assigned in
Note:
AMGIL command.
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
→
ON or pressing RESET button.
VOL.2-1180