NEC Univerge sv8500 Manual page 1643

[Sample Data Setting for the above network configuration]
MG(SIP) > set ipx_route
Select Route type(0: Exit/1: None/2: Static): 2
Select command(0: Exit/1: Set/2: Delete): 1
Select Gateway type(0: Exit/1: Gateway/2: Default
Gateway):1
Input Destination network Address:10.2.0.0
Input Subnet mask bit(0-32): 16
Input IP Address of Gateway:10.1.0.254
<< Result >>
Route type: Static
|Gateway Address|Destination network/Prefix
--------------------------------------------------
|10.1.0.254 |10.2.0.0
Are you sure? Y/N=y
MG(SIP) > set ipx_route
Select Route type(0: Exit/1: None/2: Static): 2
Select command(0: Exit/1: Set/2: Delete): 1
Select Gateway type(0: Exit/1: Gateway/2: Default
Gateway):2
Input IP Address of Default Gateway:192.168.1.254
<< Result >>
Route type: Static
|Gateway Address|Destination network/Prefix
----------------+---------------------------------
|192.168.1.254 |0.0.0.0
(29) ipx_rtp_port_no
Setting of the RTP base port number for LAN (Telephony Server network)
This command is used to assign the base port number that is used for RTP at LAN side. (Even numbers
only.)
[Setting Example]
MG(SIP) > set ipx_rtp_port_no
/16
/0
VOL.2-1390
MG-SIP128 [MG-128SIPMGG]