NEC Univerge sv8500 Manual page 1568

To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
Δ
3. SET DNS_SW
This command is used to enable/disable DNS server.
MG-T1(SIP)>SET DNS_SW
DNS Interface (Enable/Disable)[DISABLE]: ENABLE
DNS IP Address [0.0.0.0]: 10.41.1.150
DNS setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
When DISABLE is selected, the setting line of DNS IP Address is not displayed.
Note:
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
Δ
4. SET DTMF_IN
This command is used to enable/disable in-band DTMF relay.
MG-T1(SIP)>SET DTMF_IN ON
In band DTMF Relay setting succeeded.
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
5. SET Δ E_T_WAITTIME
This command is used to specify the waiting time before the Training Feature mode of Echo Canceller be-
gins. Echo Canceller Feature is used to prevent initial Echo (ranging from 500 to 1ms) occurred in the be-
ginning of speech to the Telephony Server.
MG-T1(SIP)>SET E_T_WAITTIME 0
EC Training Start Wait Timer setting succeeded.
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
Δ
6. SET EC_TRAINING
Δ
P1
Δ P1
Δ
P1
Enter the following after the command
ENABLE=DNS is valid (default)
DISABLE=DNS is invalid
Enter the IP address of DNS server
e.g. 10.41.1.150
Result is displayed.
P1: Specify the following:
ON=In-band DTMF is valid
OFF=In-band DTMF is invalid (default)
Result is displayed.
P1: Specify a waiting time before the training
feature starts (ms)
0-100=Waiting time (1 counter indicates
10ms)
Result is displayed.
VOL.2-1315
MG-T1(SIP) [SCA-24DTIA]