NEC Univerge sv8500 Manual page 1650

Input Registration Port Number.
(1024-65535(default=3456)):3456
Note: Normally this command is not required to be changed.
(40) reg_interval
Setting of the waiting time to retry after registration failure
This command is used to assign the retry waiting time when failed to register, due to the error-response
or no answer from the server when Register packet was sent to SIP server from MG-SIP128 [MG-
128SIPMGG].
[Setting Example]
MG(SIP) > set reg_interval
Input REGISTER interval timer value.(min)
(1-255(default=5)):5
Note: The conditions of this command are as follows.
• Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
• When registration per number function is effective, assign by setting MG-SIP128 [MG-128SIPMGG] using
the largest number within the same MG-SIP128 [MG-128SIPMGG] group referring to table below.
(41) response_table
Setting of response table selection
This command is used to set the response table.
[Setting Example]
MG(SIP) > set response_table
Select Response table(Error Cause to
SIP Error Response).
0=normal(default)
1=revised
Input:0
Note:
Normally this command is not required to be changed.
Amount of Numbers
1 to 300
301 to 600
601 to 900
901 to 1000
VOL.2-1397
MG-SIP128 [MG-128SIPMGG]
Assign the UDP port number that
receives the DRS packets.
(Default: 3456).
Re-register waiting time (min):
(Default: 5min)
Time (minute)
5
10
15
20
0: normal table selection (Default)
1: Select not to send a server error from MG-
SIP128 [MG-128SIPMGG] to SIP network.