NEC Univerge sv8500 Manual page 1559

[How to Read Maintenance Command]
The commands in this section are explained with defined characters. These characters' meanings are in the fol-
lowing:
CHARACTERS
[Configuration Command List]
The maintenance console uses the commands listed on the table below.
COMMAND No. SUB COMMAND
1 SP
SETUP
2 T1
1 DEFAULTROUTE
2 DHCP
3 DNS_SW
4 DTMF_IN
5 E_T_WAITTIME
6 EC_TRAINING
7 FAXERRORDETECT Assigns the FAX switching time.
8 HC_RCV_TIMER
9 INTERFACE
10 IPADDRESS
SET
11 ONE_TIME_PASS
12 OWN_NAME
13 LOOPBACK
SIGNALING_PORT_
14
NO
15 SIGNALING_QOS
16 SIPSV_IPADDRESS
17 SMOOTH_PAD
18 STARTPORT
19 VLAN
20 WARNING_TONE
First assign the network data to MG-T1(SIP) by SETUP SP command according to your network environ-
Note:
ment.
Δ
P1, P2, P3
[ ]
List of Maintenance Command
Assigns IP network data for MG-T1(SIP).
Assigns T1 interface related data for MG-T1(SIP).
Assigns Default Gateway IP address.
Selects whether DHCP feature is enabled.
Selects whether DNS feature is enabled.
Assigns in-band DTMF relay.
Assigns waiting time before starting echo canceller training.
Assigns echo canceller training.
Assigns the time recognized as timeout in receiving health check.
Assigns the communication speed and mode for LAN interface.
Assigns IP address and subnet mask of MG-T1(SIP).
Assigns one time password for security.
Assigns host name of MG-T1(SIP).
Assigns loopback settings.
Assigns a Signaling Port Number for SP-PHI.
Assigns the QoS for SIP signaling session.
Assigns IP address, port number and host name of SIP server.
Assigns smooth PAD mode of DSP.
Assigns RTP starting port.
Assigns VLAN.
Assigns Warning Tone.
Blank
Parameters
Parameter Option (indicates Not essential)
FUNCTION
VOL.2-1306
MG-T1(SIP) [SCA-24DTIA]
MEANING
PAGE
page 1309
page 1312
page 1314
page 1314
page 1315
page 1315
page 1315
page 1315
page 1316
page 1316
page 1316
page 1317
page 1317
page 1318
page 1318
page 1319
page 1319
page 1321
page 1322
page 1322
page 1322
page 1323