NEC Univerge sv8500 Manual page 1645

Input Standby timer value.(sec)(10-
3600(default=30)):30
Select Contact Header type.
0=Privacy(default)
1=SIP-URI
Input:0
[When this function is disabled]
Only the pilot number that is set in the configuration of MG-SIP128 [MG-128SIPMGG] by "set keynumber"
command registers to SIP server.
MG(SIP) > set multi_regist
Select Multi-registration mode.
0=disable(default)
1=enable
Input:0
Note 11:
When "Privacy" is selected
When "SIP-URI" is selected : Assign the SIP-URI to the User ID field of SIP message "Contact header". As-
Note: The conditions of this command are as follows.
• Use configuration command "set sip_register" to assign the SIP server for register destination.
• The assignment of "set sip_register" is necessary when registration is to be done per number.
• Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
(32) musictype
Setting of the type of music to be sent from MG-SIP128 [MG-128SIPMGG]
This command is used to select music type that is sent from MG-SIP128 [MG-128SIPMGG].
[Setting Example]
MG(SIP) > set musictype
Select Music Type.
0=Type1(default)
1=Type2
2=Type3
3=Type4
Input:0
: Assign a random value to the User ID field of SIP message "Contact header".
sign the telephone number if SIP-URI has not been assigned.
VOL.2-1392
MG-SIP128 [MG-128SIPMGG]
Assign the time value to re-reg-
ister after fault recovery
(Default 30sec).
0: Random value
1: SIP-URI Note 11
0: disable
1: enable
Select "0".
0: Type1: Minuet
1: Type2: For Elise
2: Type3: WAVE file
3: Type4: No sound