NEC Univerge sv8500 Manual page 1586

INITIAL COMMAND
1. INIT Δ CONFIGDATA
This command is used to initialize the configuration data in MG-T1(SIP).
MG-T1(SIP)>INIT CONFIG
***Warning!!***
This command initializes the configuration data.
This deletes the current setting.
Recommend to back up the setting.
Command execute or not? [Y/N]: y
Initialize authentication key or not? [Y/N]: y
Command complete.
You need to setup configuration data.
y=Initialize
n=Not initialize
y=Clear authentication key Initialize
n=Not clear authentication key
VOL.2-1333
MG-T1(SIP) [SCA-24DTIA]