NEC Univerge sv8500 Manual page 1640

Input Subnet mask bit(0-32):16
Input IP Address of Gateway:192.168.0.254
<< Result >>
Route type: Static
Gateway Address|Destination network/Prefix
----------------+--------------------------
---
192.168.0.254 |172.16.0.0
Are you sure? Y/N=y
MG(SIP)>
Note 10: Do not set routing in the segment where MG-SIP128 [MG-128SIPMGG] belongs.
• [To Assign Routing Information (Gateway Address only)]
To set a default gateway, it should be assigned to either LAN side port or SIP network side port. Usually,
assign a default gateway to SIP network side port. Two or more Default Gateways cannot be registered.
MG(SIP) > set ipx_route
Select Route type(0:Exit/1:None/2:Static):2
Select command(0:Exit/1:Set/2:Delete):1
Select Gateway type(0:Exit/1:Gateway/
2:Default Gateway):2
Specify the subnet mask. Note 10
(Default: 0)
Note: If an invalid value is set here,
Specify the gateway address.
(Default: 0.0.0.0)
/32
Note: Pressing any key other than "y"
0: Exit
1: None (Default)
2: Static
Select "2.
0: Exit (Exit the command without execut-
1: Set routing information.
2: Delete routing information.
Select "1".
0: Exit (Exit the command without execut-
1: Specify the gateway.
2: Specify the default gateway.
Select "2".
VOL.2-1387
MG-SIP128 [MG-128SIPMGG]
the following error message is
displayed. Input the valid value.
Input destination network address
invalid.
displays the following message.
Route setting command was interrupted.
ing anything.)
ing anything.)