NEC Univerge sv8500 Manual page 1631

Input IP Address.(default=0.0.0.0)
:172.16.253.4
Input Port Number.(1024-65535
(default=3456))
:3456
(20) drs_qos
Setting of ToS value of DRS server
This command is used to specify the ToS value of IP packets to be sent to DRS server.
[Setting Example]
MG(SIP) > set drs_qos
Input type: (1=IP Precedence/2=DiffServ/
3=ToS):1
Input following parameters.
Precedence(default=5, 0-7):5
Delay(default=0, 0/1):0
Throughput(default=0, 0/1):0
Reliability(default=0, 0/1):0
Cost(default=0, 0/1):0
Note: IP Precedence - ToS field is allocated as shown below.
0 1 2
Prec.
3 4 5 6
D T R C
VOL.2-1378
MG-SIP128 [MG-128SIPMGG]
IP address of DRS server
(Default: 0.0.0.0)
UDP Port number of DRS server
(Default: 3456)
When IP Precedence (=1) is selected:
Specify the precedence in an IP network
(Default: 5). 0-7 (Low - High)
Specify the low delay priority in an IP net-
work.
0: Not specified (Default)
1: Specified
Specify the throughput priority in an IP net-
work.
0: Not specified (Default)
1: Specified
Specify the reliability in an IP network.
0: Not specified (Default)
1: Specified
Specify the low cost priority in an IP net-
work.
0: Not specified (Default)
1: Specified
7