NEC Univerge sv8500 Manual page 1566

Setting multiframe format and equalizer (transmission distance) data for T1 interface:
---Mandatory Setting---
1.Multiframe (0:24MF/1:12MF)[0]: 1
2.Equalizer
(0:0-40m/1:40-80m/2:80-120m/3:120-162m/4:162m-)[4]: 0
Setting optional data for T1 interface:
---Optional Setting---
1. All Ch Make Busy
3. Remote Alarm Sending
5. Alarm Operation Mode
7. Alarm Detect/Release Type :0*
9. 4K Data Link
11.Haul Mode
13.Simultaneous Seizure
15.Layer 1 Alarm Report
17.ACK Detect Guard Time
19.Answer Detect Time
21.Recv Signaling Pattern
23.Recv Signaling A logic
25.EC NLP Mode
27.Clock Signal Mode
Change Optional setting? [Y(change)/N(current)]: y
Input Optional setting number (1-28): 1
1. All Ch Make Busy (0:Cancel/1:Set)[0]: 1
To stop SETUP T1 command and save the changed data:
---Optional Setting---
:0* 2. G.704 Mode
:0* 4. Remote Alarm Signaling
:0* 6. Alarm Release Time
8. Line Signal
:0* 10.BOM/MOS Operation
:0* 12.4K Data Link Mode
:0* 14.SSD Remote Start
:0* 16.Call Collision Processing :0
:0* 18.ACK Detect Time
:0* 20.Send Signaling Pattern
:0* 22.Send Signaling A Logic
:0* 24.EC NLP Control
:0* 26.EC/2100Hz Detect
:0* 28.Idle Code Sending
VOL.2-1313
MG-T1(SIP) [SCA-24DTIA]
Setting parameters and current
:0
:0
setting are listed.
:0
(*All the parameters are set to
:0
"0" in default setting.)
:0
:0
:0
:0
:0
:0
:0
:0
:0
Enter "Y" to change the
optional setting.
Select the setting number (1-
28) to be assigned.
When "1" is entered in the for-
mer step, for example, "1. All
Ch Make Busy" setting line is
displayed. Enter the data
depending on the selected set-
ting parameter.