NEC Univerge sv8500 Manual page 1526

Hide thumbs Also See for Univerge sv8500:

Table of Contents

[1] Internal PHE Data Assignment

MG-T1(SIP) is registered to SP-PHI. In this case, MPH is used to control SP-PHI. For the use of MPH, it is

required to make Internal PHE function valid. So Internal PHE data assignment is necessary. About the proce-

dure for the Internal PHE data assignment, refer to Vol.1, Chapter 2, "2. IP Related Basic Programming" in this

manual. The explanation of PHs including Internal PHE is also there.

[2] SP-PHI Data Assignment

MG-T1(SIP) is registered to SP-PHI. So SP-PHI data assignment is necessary. About the procedure for the SP-

PHI data assignment, refer to Vol.1, Chapter 2, "2. IP Related Basic Programming" in this manual. The expla-

nation of PHs including SP-PHI is also there.

[3] MG-T1(SIP) Data Assignment

STEP 1: ARTD (Assignment of Route Class Data)

Assign the Route Class data of Virtual Speech Channel.

*Any template is not prepared exclusively for MG-T1(SIP). As well as the route class data setting for

PA-PRTC (1.5M DIT) card, assign each parameter depending on the specification and services of the

connecting T1 carrier using existing template.

RT = Route Number of virtual speech channel

CDN2 (ONSG): 2=PB (60msec interval) or 8=PB (120msec interval)

CDN4 (INSG):

CDN60 (TC/EC): 1=EC (Echo Canceller Control for Virtual Speech Channel)

For the signal type FXO:

CDN1 (OSGS):

CDN3 (ISGS):

CDN15 (LSG):

For the signal type DID:

CDN3 (ISGS):

CDN15 (LSG):

2=PB (60msec interval) or 8=PB (120msec interval)

2=Second Dial Tone or 4=Immediate Send

1=Ground start

2=Second Dial Tone or 7=Sender (Wink Start)

5=E&M or 8=DID

MG-T1(SIP) [SCA-24DTIA]

Show Quick Links

Table of Contents