NEC Univerge sv8500 Manual page 1462

Input new Host Name: mgpri.nec.com
--- Default Gateway IP Address set ---
Current Default Gateway: 0.0.0.0
Change Default Gateway? [Y (change)/N (current)/
Q(quit)]: Y
Input new Default Gateway: 10.41.1.254
--- SIP Server IP Address & Host Name set ---
Current SIP Server/IP Address/Port Number/Host
Name:
SIP Server IP Address Port Number Host Name
1 0.0.0.0
2 0.0.0.0
3 0.0.0.0
4 0.0.0.0
5 0.0.0.0
6 0.0.0.0
7 0.0.0.0
8 0.0.0.0
9 0.0.0.0
10 0.0.0.0
11 0.0.0.0
12 0.0.0.0
13 0.0.0.0
14 0.0.0.0
15 0.0.0.0
16 0.0.0.0
17 0.0.0.0
18 0.0.0.0
19 0.0.0.0
20 0.0.0.0
Change SIP Server Information? [Y (change)/N (cur-
rent)/Q(quit)]: Y
Input new SIP Server (1-20): 1
Input new IP Address: 10.41.1.200
Input new Port Number: 5060
Is there the Host Name? [Y/N]: Y
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
5060
VOL.2-1209
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
10) Specify a new host name.
The current setting is displayed.
11) Select the default gateway setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
12) Specify the IP address of the default
gateway. Note that default gateway
should be located in the same segment
with MG(PRI).
The current setting is displayed.
13) Select the SIP Server setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
14) Specify the number of SIP Server to
be modified.
15) Specify the IP address of SIP Server.
Note 1
16) Specify a new port number.
17) Select the host name setting.
Y: Use the host name
N: Do not use the host name