NEC Univerge sv8500 Manual page 1639

When Route type = 1 is selected:
MG(SIP) > set ipx_route
Select Route type(0:Exit/1:None/2:Static):1
<< Result >>
Route type: None
Are you sure? Y/N=y
MG(SIP) >
When Route type = 2 is selected:
• [To Assign Destination Network Address and Gateway Address]
Usually, gateway data should be set as 'Static' at LAN (Telephony Server network) side.
MG(SIP) > set ipx_route
Select Route type(0:Exit/1:None/2:Static):2
Select command(0:Exit/1:Set/2:Delete):1
Select Gateway type(0:Exit/1:Gateway/
2:Default Gateway):1
Input Destination network
Address:172.16.0.0
0: Exit
1: None (Default)
2: Static
Select "1".
Note: Pressing any key other than "y"
0: Exit
1: None (Default)
2: Static
Select "2".
0: Exit (Exit the command without execut-
1: Set route information.
2: Delete route information.
Select "1".
0: Exit (Exit the command without execut-
1: Specify the gateway.
2: Specify the default gateway.
Select "1".
Specify the network address. Note 10
(Default: 0.0.0.0)
VOL.2-1386
MG-SIP128 [MG-128SIPMGG]
causes the following message.
Route setting command was interrupted.
ing anything.)
ing anything.)