NEC Univerge sv8500 Manual page 1661

Note:
The conditions of this command are as follows.
• Normally this command is not required to be changed.
• RTP ports occupy 256 (128 × 2) ports (counting from the RTP base port number).
• If you select one port in the number of port setting, be careful not to use the same RTP port number (set by
"set sip_rtp_port_no" or "set ipx_rtp_port_no" command) when setting the non-default SIP network RTP
base port number.
(54) sip_server
Setting of the information of SIP server
This command is used to assign an IP address or a Fully Qualified Domain Name (FQDN), and port num-
ber, type, and SIP domain of the SIP server.
The following figure shows an example of display.
When IP address (=0) is selected:
[IPv6]
MG(SIP) > set sip_server
Select SIP server type.
0=IPAddress(default)
1=FQDN
Input:0
Input SIP server IP Address. Input SIP server
IP Address. (default=::)
: 2001:db8::860
Input SIP server Port Number.
(1024-65535(default=5060)):5060
Select SIP server Router type.
0=Strict(default)
1=Loose
Input:0
Select the setting of rport(RFC3581)
function.
0=disable (default)
1=enable
Input: 0
VOL.2-1408
MG-SIP128 [MG-128SIPMGG]
When IP address (=0) is selected.
(Default: 0)
Assign the IP address of the proxy
server
(Default: ::).
Assign the port number of the proxy
server
(Default: 5060)
Select a Strict router or Loose router for
the proxy server
(Default: 0)
0: Strict router
1: Loose router
Select "0".
Enable/disable the rport (RFC3581)
function.
(Default: 0)
Note 11, Note 18