NEC Univerge sv8500 Manual page 1646

(33) no_media_code
Setting of the SIP Error Response code
This command is used to set a SIP error response code. When 415 is set as a response code, 415 Unsup-
ported Media Type is sent instead of response code 488 if an unsupported codec is received.
[Setting Example]
MG(SIP) > set no_media_code
Input the SIP Error Response code when
the unsupported codec.
(400-606 (default=488)): 415
Note: The conditions of this command are as follows.
• Accept, Accept-Encoding and Accept-Language headers are not added to 415 Unsupported Media Type.
• 415 Unsupported Media Type response supports only when the request message is the INVITE or UPDATE
message.
(34) out_of_area_code
Setting of the out-of-area error response
This command is used to set the out-of-area (IPX network) error response.
[Setting Example]
MG(SIP) > set out_of_area_code
Input the SIP Error Response code when the out
of area.
(400-606(default=408)):408
Note: Normally this command is not required to be changed.
(35) prack
Setting of PRACK (Provisional Response Acknowledgment) function (RFC3262)
This command is used to enable/disable Provisional Response Acknowledgement (PRA) function
(RFC3262). When this is set enabled, the 18x cyclical-send of provisional response function can be spec-
ified.
[Setting Example]
MG(SIP) > set prack
Type any number between 400 and 606 (415 is
typed in this manual as an example).
VOL.2-1393
MG-SIP128 [MG-128SIPMGG]
Set the error response code.
(Default: 408)