NEC Univerge sv8500 Manual page 1649

Input a Dummy string.(MAX32(strings))
When "2" is selected:.
MG(SIP) > set privacy_pattern
Select Privacy pattern of Calling Party
Number.
0=DisplayName(default)
1=Remote-Party-ID
2=RFC3325
Input:2
Select RFC3325 pattern.
0=Pattern 1:privacy_only(default)
1=Pattern 2:TEL-URI
2=Pattern 3:unused
3=Pattern 4:SIP-URI
4=Pattern 5:P-Associated-URI
5=pattern 6:SIP-URI(no privacy)
Input:0
Note 12: Use of P-Preferred-ID headers of INVITE message differs for each pattern.
When Pattern 1 is set: P-Preferred-ID header is not attached.
When Pattern 2 is set: P-Preferred-ID header is attached. (tel: is used)
When Pattern 3 is set: Not used.
When Pattern 4 is set: P-Preferred-ID header is attached.
When Pattern 5 is set: P-Preferred-ID header is attached. (P-Associated-URI is used)
When Pattern 6 is set: P-Preferred-ID header is attached.
Note 13: For enabling this parameter, note the following conditions:
• This parameter is available for SP-4051 MGSIP PROG-G Issue 2 or later.
• This parameter cannot be assigned when "set multi_regist" or "set 184toprivacy" is enabled.
Note:
Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
(39) registration_port_no
Setting of the UDP port number that receives DRS packets
This command is used to specify the UDP port number that receives the registration packets.
[Setting Example]
MG(SIP) > set registration_port_no
:anonymous
VOL.2-1396
MG-SIP128 [MG-128SIPMGG]
Enter a dummy string (specified by pro-
vider) in maximum of 32 characters.
0: DisplayName (Default)
1: Remote-Party-ID
2: RFC3323/3325(P-Preferred-ID/Pri-
vacy)
Select an RFC3325 pattern Note 12
0: privacy_only (Default)
1: TEL-URI
2: unused
3: SIP-URI
4: P-Associated-URI
5: SIP-URI (no privacy) Note 13