NEC Univerge sv8500 Manual page 1493

Δ
20. SHOW PADP1
This command is used to display the specified PAD register for voice quality tuning. The following is an
example in the case of displaying PAD0.
MG-PRI(SIP)>SHOW PAD0
value is 0x0000
A-law/u-law Setting
PAD Selection
PAD Control
PAD Pattern No.
Data PAD Pattern No.
21. SHOW Δ PRI_COMMON1
This command is used to display the common settings 1 for trunk.
MG-PRI(SIP)>SHOW PRI_COMMON1
value is 0x0215
Remote Alarm Sending
Signal All 1
Idle Code Sending
Dch Back-up
Layer 1 Alarm Sending
Haul Mode
EC NLP Control
EC NLP Mode
EC 2100Hz Detect
Music Int/Ext
Music No.
Clock Mode
Layer 1 Alarm Display
P1-Specify the register number to be displayed.
0-4=PAD Register Number
The current setting is displayed.
- CODEC
:0
0=MGC Control (PBX System Data)
:0
1=μ-law
:0
2=A-law
:0
3=Convert from A-law to μ-law
:0
4=Convert from μ-law to A-law
- PAD selection (0/1=Standard/Flexible)
- PAD Control
0=Receiving Control (ISDN Network→MG)
1=Sending Control (MG→ISDN Network)
2=Fixed to ARTD
3=Sending/Receiving Control
- PAD Pattern number (0-4)
- Data PAD Pattern Number
0=64K
1 - 4=Not available
- Flexible PAD #N-Recv ((-16)-(20))
- Flexible PAD #N-Send ((-16)-(20))
The current setting is displayed.
- Remote Alarm Sending (0/1=Enable/Disable)
:0
- Signal All 1(0/1=Disable/Enable)
:0
- Idle Code Sending (0/1=Disable/Enable)
:0
- Dch Back-up (0/1=Disable/Enable)
:0
- Layer 1 Alarm Sending (0/1=Enable/Disable)
:0
- Haul Mode (0/1=Short/Long)
:0
- EC NLP Control (0/1=Disable/Enable)
:1
- EC NLP Mode
:0
(0/1=Background Noise/Fixed Level)
:0
- EC 2100Hz Detect
:0
(0/1=Disable/Enable)
:5
- Select Music Source (0/1=Internal/External)
:0
- Music No. (0=Fur Elise/1=Maiden's prayer/5=Minuet)
- Clock mode (0/1=Secondary/Primary)
:1
- Layer 1 Alarm LED display (0/1=Enable/Disable)
VOL.2-1240
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]