NEC Univerge sv8500 Manual page 1635

Note:
Normally this command is not required to be changed.
(24) hc_timer
Setting of health check timer value
This command is used to specify the health check time-out value.
[Setting Example]
MG(SIP) > set hc_timer
Input H/C timer value.(sec)
(130-65535(default=240)):240
Note:
Normally this command is not required to be changed.
(25) interface
Setting of the operation speed and operation mode of an interface
This command is used to assign the Ether speed and the duplex type to each port on MG-SIP128 [MG-
128SIPMGG].
[Setting Example]
MG(SIP) > set interface
Select Ether[1] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:0
Select Ether[2] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:1
Select Ether[2] duplex.
1=Half
2=Full
Input:2
Note 8: When "Automatic Negotiation" is selected, "AUTO" is automatically applied to the interface.
Therefore, this command line will not appear for interface that is specified as "Automatic Negoti-
ation".
Assign the Health Check timer value (Default: 240
seconds).
Assign an Ether speed type to Ether 1.(Example:
when AUTO is set.)
0=Automatic Negotiation (Default)
1=10 Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed) Note 9
Select "0". Note 8
Assign an Ether speed type to Ether 2.(Example:
when 100M/Full is set.)
0=Automatic Negotiation (Default)
1=10Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed) Note 9
Select "1".
Assign a duplex type to Ether 1 and Ether 2.
1=Half Duplex
2=Full Duplex
Select "2".
VOL.2-1382
MG-SIP128 [MG-128SIPMGG]