NEC Univerge sv8500 Manual page 1495

Δ
24. SHOW PRI_E1_2
This command is used to display E1 settings for trunk.
MG-PRI(SIP)>SHOW PRI_E1_2
value is 0x1000
Multi-frame Remote Alarm
Alarm Release Timing
Line Signal
CRC4
DTI Mode
CRC Multi-frame Format
Ebit Automatic Sending
TS16 Control
Dch Mode
Loop Back Pattern
Alarm Detect/Release Type
25. SHOW Δ RTP_STOP_DETECT
This command is used to display the time-out value for RTP reception.
MG-PRI(SIP)>RTP_STOP_DETECT
RTP Stop Detect Timer is 3sec.
Δ
26. SHOW SIGNALING_PORT_NO
This command is used to display the port number of signaling.
MG-PRI(SIP)>SIGNALING_PORT_NO
Signaling port number is 5060.
27. SHOW Δ SIGNALING_QOS
This command is used to display the QoS of signaling.
MG-PRI(SIP)>SIGNALING_QOS
Signaling QOS is 0xC0. (QOS = TOS)
PRECEDENCE =6
DELAY =0
THROUGHPUT =0
RELIABILITY =0
COST =0
The current setting is displayed.
- Multi-frame Remote Alarm (0/1=Enable/Disable)
:0
- Alarm Release Timing (0/1=Short/Long)
:0
- Line Signal (0/1=HDB3/AMI)
:0
- CRC4 (0/1=Disable/Enable)
:1
- DTI Mode (0: Fixed)
:0
- CRC Multi-frame Format (0/1=Disable/Enable)
:0
- Ebit Automatic Sending (0: Fixed)
:0
- TS16 Control (0/1=Data Through/Signaling
:0
- Dch Mode (0/1=ITU-T/AT&T)
:0
- Loop Back Pattern (0: Fixed)
:0
- Alarm Detect/Release Type (0/1=ETSI/ITU-T)
:0
VOL.2-1242
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.