NEC Univerge sv8500 Manual page 1523

16.3 Startup MG-T1(SIP) and Basic Tests
This section explains procedures for startup and basic tests. Follow the procedure below.
STEP 1: Data Assignment by PCPro
1. Internal PHE Data Assignment
2. SP-PHI Data Assignment
3. MG-T1(SIP) Data Assignmet
4. Security Data Assignment
STEP 2: Terminal Software Setting on Maintenance Console
1. Connection between PC (maintenance console) and CONSOLE Connector
2. Terminal Software Activation
3. Setting of Terminal Software
STEP 3: Power ON
STEP 4: Configuration Command Assignment
1. One Time Password Assignment
2. Selection whether to use DHCP/DNS server
3. Network Data Assignment
STEP 5: Cable Connection
1. Connection between MG-T1(SIP) and LAN
2. Connection between MG-T1(SIP) and T1 line
STEP 6: Basic Test Procedures
1. Basic Connection Test
2. Alarm Information Check
3. Loop-Back Test
END
VOL.2-1270
MG-T1(SIP) [SCA-24DTIA]