NEC Univerge sv8500 Manual page 1530

16.3.2 Terminal Software Setting on Maintenance Console
STEP 1: Connect a PC (maintenance console) to CONSOLE connector.
STEP 2: Run terminal software (e.g. HyperTerminal) on the Maintenance Console.
STEP 3: Set the parameter of the terminal software as follows:
• Port:
• Baud Rate:
• Data:
• Parity:
• Stop Bit:
• Flow Control: None
For the detailed procedure of Terminal Software (HyperTerminal) setting, refer to Vol.1, Chapter 2, "2. IP
Note:
Related Basic Programming" in this manual.
COM1 (depending on PC setting)
9600 bps
8 bits
None
1
VOL.2-1277
MG-T1(SIP) [SCA-24DTIA]
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required