NEC Univerge sv8500 Manual page 1605

• The MG-SIP128 [MG-128SIPMGG] connects to a network with transmitting speed of 1Gbps.
[SPEED lamp is lighting in green]
• The MG-SIP128 [MG-128SIPMGG] connects to a network with transmitting speed of 100Mbps.
If you expected transmitting speed of 1Gbps, check a connected network device and a cable be-
tween them.
[SPEED lamp is not lighting]
• The MG-SIP128 [MG-128SIPMGG] connects to a network with transmitting speed of 10Mbps.
If you expected transmitting speed of 1Gbps or 100Mbps, check a connected network device and a
cable between them.
Step7: Checking the lighting of ONLINE lamp.
If the settings are correct, ONLINE lamp of MG-SIP128 [MG-128SIPMGG] lights in green.
17.3.6 Operation Check
Make sure the MG-SIP128 [MG-128SIPMGG] is in normal operation by the following procedure.
Step1: When the configuration settings are completed, reboot the MG-SIP128 [MG-128SIPMGG]
by using "reboot" command.
Step2: Make sure the following message appears on the Maintenance Console after rebooting.
*****************************************
* MG(SIP) ONLINE START
*****************************************
Step3: Make sure the registration status of the Telephony Server network and SIP network by us-
ing "show status" command in the configuration mode. If "Registration is OK." message ap-
pears, MG-SIP128 [MG-128SIPMGG] is in operating state.
MG(SIP) > show status
0:Port status
1:IPX status
2:SIP status
3.CH status
9:Exit
Please choose reference number:1
MG(SIP) > IPX Registration Information
*
Port status (Default)
Telephony Server network registration status
SIP network registration status
Information on channels in use
Exit
Select a desired status you want to check.
The registration information of MG-SIP128
[MG-128SIPMGG] is displayed.
VOL.2-1352
MG-SIP128 [MG-128SIPMGG]