NEC Univerge sv8500 Manual page 1532

16.3.4 Configuration Command Assignment
Assign the network data to MG-T1(SIP) by configuration command operation on the maintenance console.
"SIP server" used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
Note:
for MG-T1(SIP) using SIP.
The setting data here is an example. Assign the network data adjusting to your network configuration.
Note:
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
The system will require a one-time password for authentication at initial startup. Enter the same pass-
word with the one entered in SIP server by ASECL command. As long as you don't enter a one-time
password, you cannot move on to the next step.
DP OK
MG-ID: xxxxxx
Boot program version : SPxxxx SH7751R CBOOT-1 PROG-A
[xx.xx.xx.xx]
Main program version : SPxxxx MG DTI PROG-A [xx.xx.xx.xx]
H/W PKG information
DSP information
DSP information
Starting Boot program.....
--- Online program Initial start --- (wait for a while)
:
:(Omitted)
:
No One Time Password!!
Please input a one time password.
One Time Password : •••••
Erase start...
Erase OK!
Write start...
Write OK!
One time password setting succeeded.
STEP 2: Type "usrConsole" following the OS prompt and press ENTER key.
: CA-CC00 001
: DSP-K-AC49kernel [xx.xx.xx.xx]
: DSP-P-AC490012ae3-S [xx.xx.xx.xx]
VOL.2-1279
MG-T1(SIP) [SCA-24DTIA]