NEC Univerge sv8500 Manual page 1569

This command is used to enable/disable the Training Feature mode of Echo Canceller. Echo Canceller Fea-
ture is used to prevent initial Echo (ranging from 500 to 1ms) occurred in the beginning of speech to the
Telephony Server.
MG-T1(SIP)>SET EC_TRAINING ON
EC Training Feature setting succeeded.
Δ
7. SET FAXERRORDETECT
This command is used to specify the available time to be switched to FAX mode.
MG-T1(SIP)>SET FAXERRORDETECT 1
FAX Enable Timer setting succeeded.
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
ΔHC_RCV_TIMERΔ
8. SET
This command is used to specify a value recognized as timeout in receiving health check.
MG-T1(SIP)>SET HC_RCV_TIMER 120
Impedance setting succeeded.
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
Note:
command.
9. SET Δ INTERFACE
This command is used to specify the communication speed of LAN interface. Be sure to assign this data
adjusting to the network devices (router, switch, or HUB, etc.). This data can be set also in SETUP SP com-
mand.
MG-T1(SIP)>SET INTERFACE
SPEED(AUTO/100M/10M):100M
DUPLEX(FULL/HALF):HALF
Ethernet Speed setting succeeded.
Δ
P1
P1
1) Select the communication speed of LAN interface
AUTO=Auto negotiation (default)
100M=100Mbps fixed mode
10M=10Mbps fixed mode
2) Select duplex mode (*not displayed when SPEED=AUTO)
FULL=Full duplex
HALF=Half duplex
Result is displayed.
VOL.2-1316
P1: Specify the following:
ON=Training function is valid
OFF=Training function is invalid
ONCE=Training function is valid only once (default)
Result is displayed.
P1: Specify the available time to switch to FAX.
0=FAX switching is unavailable.
1-5=Available time to be switched to FAX (minutes)
OFF=Always-on FAX switching
Result is displayed.
P1: Specify a time (second) recognized as timeout in
receiving health check.
120-300=Available time.(Default: 150)
Result is displayed.
MG-T1(SIP) [SCA-24DTIA]