Table of Contents
Advertisement
show ip cam stack-unit
Display CAM entries.
Syntax
show ip cam stack-unit {0–5} [port-set {pipe-number} | {ip-
address mask [longer-prefixes]| detail | member-info | summary]
Parameters
0–5
pipe-number
ip-address
mask [longer-
prefixes]
detail
member-info
summary
Command
•
Modes
•
Command
Version 8.3.16.1
History
Usage
The following describes the show ip cam command shown in the following
Information
example.
Field
Destination
EC
CG
V
640
Enter the stack-unit ID from 0 to 5
Enter the number of the Port-Pipe number. The range is
from 0 to 0
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. Enter the keywords longer-
prefixes to view routes with a common prefix.
Enter the keyword detail to display the group index ID
used by the ecmp routes in the CAM.
Enter the keywords member-info to display the group index
used by the ecmp, the number of egress ports (members) for
the ecmp, and the port details of each member.
The detail information under member-info gives the MAC
address, VLAN ID, and gateway of every member port of the
ecmp.
(OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Displays the destination route of the index.
Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
Displays 0.
Displays a 1 if the entry is valid and a 0 otherwise.
IPv4 Routing
Advertisement
Table of Contents
