Honda ACCORD HYBRID 2005 Service Manual page 497

10. Reconnect PCM connector E (31P).
11. Turn the ignition switch ON (II).
12. Reset the PCM w i t h the HDS.
13. Do the PCM idle learn procedure (see page 11-340).
14. Turn the ignition switch OFF.
15. Turn the ignition switch ON (II), and wait
10 seconds.
16. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P2552 is indicated, check for poor
connections or loose terminals at the throttle
actuator control module relay, the throttle actuator
control module, and the PCM, then go to step 1. If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTCs troubleshooting.
NO—Troubleshooting is complete. •
17. Update the PCM if it does not have the latest
software, or substitute a known-good PCM
(see page 11-6).
18. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P2552 is indicated, check for poor
connections or loose terminals at the throttle
actuator control module relay, the throttle actuator
control module, and the PCM, then go to step 1. If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTCs troubleshooting.
NO—If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 1 1 - 2 1 9 ) . •