Honda ACCORD HYBRID 2005 Service Manual page 499

16. Remove the throttle actuator control module relay
(A).
17. Measure voltage between throttle actuator control
module relay 4P connector terminal No. 1 and body
ground.
THROTTLE ACTUATOR CONTROL
M O D U L E RELAY 4P CONNECTOR
+ B (WHT/GRN)
Wire side of female terminals
Is there battery voltage?
Y E S — G o t o step 19.
N O — G o t o step 18.
18. Check the No. 1 THROTTLE ACTUATOR CONTROL
(DBW) (15 A) fuse in under-dash fuse/relay box.
Is the fuse OK ?
YES—Repair open in the wire between the throttle
actuator control module relay ( + B line) and the
No. 1 THROTTLE ACTUATOR CONTROL (DBW)
(15 A) fuse, then go to step 50.
NO—Repair short in the wire between the throttle
actuator control module relay ( + B line) and the
No. 1 THROTTLE ACTUATOR CONTROL (DBW)
(15 A) fuse, then go to step 50.
19. Install the throttle actuator control module relay.
20. Turn the ignition switch ON (II).
21. Measure voltage between throttle actuator control
module 16P connector terminal No. 2 and body
ground.
THROTTLE A C T U A T O R C O N T R O L
MODULE 16P C O N N E C T O R
+ B (YEL/GRN)
1
2 6 7 8
9 1 0 1 1 1 2
/
1 4
/ /
W i r e side of female terminals
Is there battery voltage for about 2 seconds?
YES—Substitute a known-good throttle actuator
control module (see page 11-265), then go to step
50 and recheck. If DTC U0107 is not indicated,
replace the original throttle actuator control
module (see page 11-265), then go to step 50.
N O — G o t o step 22.
(cont'd)
11-259