Variable Cylinder Management (VCM) System
VTEC Solenoid Valve Filter
Replacement
1. Remove the intake manifold cover (see step 1 on
page 9-3).
2. Disconnect the VTEC solenoid valve 2P connector
(A) and the EOP sensor 3P connector (B).
3. Remove the VTEC solenoid valve assembly (C)
f r o m the rear bank cylinder head, and check the
VTEC solenoid valve filter (D) for clogging. If it is
c l o g g e d , replace the solenoid valve filter, the
engine oil filter, and the engine oil.
4. Install the VTEC solenoid valve assembly in the
reverse order of removal.
VTEC Solenoid Valve Replacement
1. Remove the intake manifold cover (see step 1 on
page 9-3).
2. Disconnect the VTEC solenoid valve 2P connector
3. Remove the VTEC solenoid valve (B).
4. Install the VTEC solenoid valve in the reverse order
of removal w i t h new O-rings (C).
11-280