Honda ACCORD HYBRID 2005 Service Manual page 513

9. Check the oil pressure.
Does the oil pressure increase to at least 30 kPa
(0.3 kgf/cm
2
, 4.3psi)?
YES—Replace the EOP sensor (see page 11-281),
then go to step 10.
NO—Replace the VTEC solenoid valve (see page
11-280), then g o t o step 10.
10. Turn the ignition switch OFF.
11. Reconnect all connectors.
12. Turn the ignition switch ON (II).
13. Reset the PCM w i t h the HDS.
14. Do the PCM idle learn procedure (see page 11-340).
15. Test-drive under these conditions:
• Engine coolant temperature above 167 °F (75 °C)
• A/T in D position
• Engine speed at 1,500—3,000 rpm
16. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P2646 is indicated, check for poor
connections or loose terminals at the VTEC
solenoid valve, the EOP sensor, and the PCM, then
go to step 1. If any other Temporary DTCs or DTCs
are indicated, go to the indicated D T C s
troubleshooting.
NO—Go to step 17.
17. Monitor the OBD STATUS for DTC P2646 in the
DTCs MENU w i t h the HDS.
Does the screen indicate PASSED?
Y E S — T r o u b l e s h o o t i n g is c o m p l e t e . •
NO—If the screen indicates FAILED, check for poor
connections or loose terminals at the EOP sensor
and the PCM, then go to step 1 and recheck. If the
screen indicates NOT COMPLETED, go to step 15
and recheck.
11-273