Ip Msdp Default-Peer - Dell S4810 Reference Manual

Parameters
number
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.4.1.0
Related show ip msdp sa-cache rejected-sa
Commands

ip msdp default-peer

Define a default peer from which to accept all source-active (SA) messages.
S4810
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address} list name command.
Parameters
peer address
list name
Defaults Not configured.
Command CONFIGURATION
Modes
1104
Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the peer address in a dotted decimal format (A.B.C.D.)
Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Multicast Source Discovery Protocol (MSDP)