Redundancy Sfm Standby - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0

redundancy sfm standby

Place the SFM in an offline state.
S4810
Syntax
redundancy sfm standby
To place the SFM in an online state, use the no redundancy sfm standby
command.
Default The SFM is online by default.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version 7.5.1.0
Usage When you insert or remove a secondary RPM with logical SFM, the system must
Information add or remove the backplane links to the switch fabric trunk. To avoid traffic
disruption, use this command when you insert the secondary RPM. When you
execute this command, the logical SFM on the standby RPM is immediately taken
offline and the SFM state is set as "standby".
Example
Dell#show sfm all
Switch Fabric State: up
700
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
NOTE: This command could affect traffic when taking the secondary SFM
offline.
High Availability (HA)