Hello; Management-Interface - Dell S4810 Reference Manual

show lldp neighbors

hello

Configure the rate at which the LLDP control packets are sent to its peer.
S4810
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults 30 seconds
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0

management-interface

Enable and configure LLDP protocol parameters on the management interface.
S4810
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no
management-interface command.
1076
— displays the LLDP neighbors.
Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP)