Show Isis Protocol - Dell S4810 Reference Manual

Field
Circuit Id
Example
The bold sections below identify that Multi-Topology IS-IS is enabled.
FTOS#show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02
!
FTOS#show isis neighbors detail
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es):
49.0000.0001
Adjacency being used for MTs: IPv4 IPv6
FTOS#

show isis protocol

Display IS-IS routing information.
S4810
Syntax
show isis protocol
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Example
The bold section identifies that Multi-Topology IS-IS is enabled.
FTOS#show isis protocol
IS-IS Router: <Null Tag>
1016
Description
The neighbor's interpretation of the designated router for
the interface.
IP Address(es): 25.1.1.3*
MAC Address: 0000.0000.0000
Hold Time: 28
Link Local Address: fe80::201:e8ff:fe00:492c
Topology: IPv4 IPv6 , Common (IPv4 IPv6 )
EXEC
EXEC Privilege
Introduced on the Z9000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Intermediate System to Intermediate System (IS-IS)