Multi-Topology - Dell S4810 Reference Manual

Defaults narrow; if no Level is specified, Level-1 and Level-2 are configured.
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version
8.3.12.0
Usage
If you enter the metric-style wide command, the Dell Networking OS
Information
generates and accepts only new-style TLVs. The router uses less memory and
other resources rather than generating both old-style and new-style TLVs.
The new-style TLVs have wider metric fields than old-style TLVs.
Related isis metric
Commands

multi-topology

Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
S4810
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Parameters
transition
Defaults Disabled
Command CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
998
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— configures a metric for an interface.
Intermediate System to Intermediate System (IS-IS)