Dot1X Auth-Fail-Vlan - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.4.1.0
Related dot1x authentication (Configuration)
Commands

dot1x auth-fail-vlan

Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.
S4810
Syntax
dot1x auth-fail-vlan vlan-id [max-attempts number]
To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan
vlan-id [max-attempts number] command.
Parameters
vlan-id
max-attempts
number
Defaults 3 attempts
Command CONFIGURATION (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.7.0
Version 7.6.1.0
Usage
If the host responds to 802.1X with an incorrect login/password, the login fails. The
Information
switch attempts to authenticate again until the maximum attempts configured is
Security
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— enables dot1x globally.
Enter the VLAN Identifier. The range is from 1 to 4094.
(OPTIONAL) Enter the keywords max-attempts then
number of attempts desired before authentication fails. The
range is from 1 to 5. The default is 3.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series, S-Series, and E-Series.
1489