Ipv6 Unicast-Routing - Dell S4810 Reference Manual

Usage
When the interface goes down, Dell Networking OS withdraws the route. The route
Information
is re-installed, by Dell Networking OS, when the interface comes back up. When a
recursive resolution is "broken," Dell Networking OS withdraws the route. The route
is re-installed, by Dell Networking OS, when the recursive resolution is satisfied.
After an IPv6 static route interface is created, if an IP address is not assigned to a
peer interface, the peer must be manually pinged to resolve the neighbor
information.
Example
Dell(conf)#ipv6 route ?
X:X:X:X::X
Dell(conf)#ipv6 route 44::0 ?
/nn
Dell(conf)#ipv6 route 44::0 /64 ?
X:X:X:X::X
gigabitethernet
loopback
null
port-channel
tenGigabitethernet
fortyGigE
tunnel
vlan
Dell(conf)#ipv6 route 44::0 /64 33::1 ?
<1-255>
permanent
tag
Dell(conf)#ipv6 route 44::0 /64 33::1
Dell(conf)#ipv6 route 44::0 /64 tengigabitethernet 0/1 ?
X:X:X:X::X
Dell(conf)#ipv6 route 44::0 /64 tengigabitethernet 0/1 66::1
Dell(conf)#
Related show ipv6 route
Commands

ipv6 unicast-routing

Enable IPv6 Unicast routing.
S4810
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command CONFIGURATION
Modes
930
IPv6 prefix x:x::y
/nn Mask in slash format
Forwarding router's address
Gigabit Ethernet interface
Loopback interface
Null interface
Port-Channel interface
TenGigabit Ethernet interface
FortyGigabit Ethernet interface
Tunnel interface
Vlan interface
Distance metric for this route
Permanent route
Set tag for this route
Forwarding router's address
— views the IPv6 configured routes.
IPv6 Basics